If you're thinking about getting asphalt installed, either as a
driveway or something else, knowing how it's installed is important. Not
only will it help you know what to expect during the installation, but
you will understand where your hard earned money is going. Here is some
information on asphalt installation to help you understand the process
before you choose a paving company.
The Stone Layer
Typically, asphalt installation begins with the company putting down a layer of stone or gravel. Many contractors use crushed gravel as it is the least expensive base to use for the asphalt. If you want the best sort of underlay for your asphalt, you can request a larger stone - however, be prepared as it may cost you more. Once the stone layer has been put in, the contractor will move on to the pouring the asphalt.
Pouring the Asphalt
Generally, after the stone has been selected and placed where it is needed, the contractors will pour the asphalt. You may notice that the gravel extends a few inches past where the asphalt is poured. This is good - if the asphalt made it to the sides of the gravel to the dirt or grass, it can easily break off at the sides as there is nothing supporting it. This will make your driveway look terrible!
Leveling
After the asphalt is poured, you will notice your contractor using a machine to straighten or level the surface of the driveway. This is to make sure everything is perfectly level and that there are no bumps or areas that are higher or lower than the rest of the asphalt. When this is finished, your asphalt only needs to cool and set up and you will have a brand new driveway. The time it takes to finish your driveway depends on how large it is and many other variables. Your contractor will discuss this with you before the job is started.
The Stone Layer
Typically, asphalt installation begins with the company putting down a layer of stone or gravel. Many contractors use crushed gravel as it is the least expensive base to use for the asphalt. If you want the best sort of underlay for your asphalt, you can request a larger stone - however, be prepared as it may cost you more. Once the stone layer has been put in, the contractor will move on to the pouring the asphalt.
Pouring the Asphalt
Generally, after the stone has been selected and placed where it is needed, the contractors will pour the asphalt. You may notice that the gravel extends a few inches past where the asphalt is poured. This is good - if the asphalt made it to the sides of the gravel to the dirt or grass, it can easily break off at the sides as there is nothing supporting it. This will make your driveway look terrible!
Leveling
After the asphalt is poured, you will notice your contractor using a machine to straighten or level the surface of the driveway. This is to make sure everything is perfectly level and that there are no bumps or areas that are higher or lower than the rest of the asphalt. When this is finished, your asphalt only needs to cool and set up and you will have a brand new driveway. The time it takes to finish your driveway depends on how large it is and many other variables. Your contractor will discuss this with you before the job is started.
No comments:
Post a Comment